|
Sketcher Reorient |
| Ubicación en el Menú |
|---|
| Part design → Reorient sketch |
| Entornos de trabajo |
| Sketcher, PartDesign |
| Atajo de teclado por defecto |
| Ninguno |
| Introducido en versión |
| - |
| Ver también |
| Map sketch, New Sketch |
Description
The 
Sketcher ReorientSketch tool places a sketch on one of the main planes with an optional offset. It can also be used to detach a sketch.
Usage
- Select a sketch.
- There are several ways to invoke the tool:
- Press the Reorient Sketch button (not available in the PartDesign Workbench).
- Select the Sketch → Reorient Sketch option from the menu.
- Press the
- If the sketch is attached:
- The Sketch Has Support dialog opens.
- Press the Yes button to detach the sketch.
- The Choose Orientation dialog opens.
- Optionally press the Cancel button to only detach the sketch and finish the tool.
- Specify the plane for the orientation. The plane is relative to the local coordinate system the sketch is in:
- If the Reverse direction checkbox is not checked:
- Top: XY-plane
- Front: XZ-plane
- Right: YZ-plane
- If the Reverse direction checkbox is checked:
- Bottom: XY-plane
- Rear: XZ-plane
- Left: YZ-plane
- If the Reverse direction checkbox is not checked:
- Optionally change the Offset. The offset is measured along the Z, Y or X-axis of the local coordinate system.
- Press the OK button.
Esta página ha sido recuperada de https://wiki.freecad.org/Sketcher_ReorientSketch