Donate

Introducción

The Combo View appears in a panel called Model. It combines the Tree View (upper section) and the Property View (lower section).

The Task Panel, which used to be part of the Combo View, is a separate panel called Tasks in 1.0 and above. It can be docked on top of the Combo View to achieve the compact layout of earlier versions.

The Combo View (Model tab) with docked Task Panel (Tasks tab)

Dock Task Panel on top of Combo View

1. Make sure the Combo View is docked along an edge of the FreeCAD window.
2. Move the cursor to the very top of the Task Panel.
3. The arrow becomes a hand.
4. Hold down the left mouse button and drag the Task Panel on top of the Combo View.
5. Move vertically until both the upper and lower sections of the Combo View are highlighted.
   
6. Release the mouse button.

Preferences

See also: Preferences Editor.

The Combo View is available if Edit → Preferences → General → General → Tree View and Property View mode is set to Combined. If it is set to Independent the Tree View and the Property View appear as separate panels.