Donate

External Intersection

Select Origin

Sketcher

Descrição

The Sketcher CarbonCopy tool copies all geometry and constraints from another sketch into the active sketch.

Dimensional constraints which exist before the copy operation remain linked to the original sketch's dimensional constraints through expressions.

Usage

1. Make sure you are in the edit mode of an existing sketch. This sketch is the target of the operation.
2. There are several ways to invoke the tool:
   • Press the Carbon Copy button.
   • Select the Sketcher → Sketcher Tools → Carbon Copy option from the menu.
   • Use the keyboard shortcut: G then W.
3. The cursor changes to a cross with the tool icon.
4. Pick an edge from another sketch. This sketch is the source of the operation. See Notes.
5. Geometry elements as well as constraints are copied into the active sketch.
6. This tool always runs in continue mode: optionally copy additional sketches.
7. To finish, right-click or press Esc, or start another geometry or constraint creation tool.

Notes

• In the PartDesign Workbench it is possible to select the sketch to carbon copy from outside the Body of the currently active sketch, but only if the Ctrl key is held down during selection.
• The sketch to carbon copy should be plane-parallel to the currently active sketch. If that is not the case the Ctrl and Alt keys must be held down during selection. This works for sketches located outside the active Body as well.
• If construction mode is active, copied geometry is created as construction geometry.
• The complete sketch is copied, it is not possible to select only a portion. But after copying you can delete unwanted elements.

External Intersection

Select Origin

Sketcher