|
Menu location |
---|
Fasteners → Match for tap hole |
Workbenches |
Fasteners |
Default shortcut |
None |
Introduced in version |
- |
See also |
Fasteners MatchTypeOuter |
Описание
The Fasteners MatchTypeInner command behaves as a toggle with the Fasteners MatchTypeOuter command. When Fasteners MatchTypeInner is selected, circular edges are considered to be tap holes when new fasteners are attached to them. This determines the default dimensions of those fasteners. This setting is not used for countersunk screws.
Применение
- There are several ways to invoke the command:
- Press the
Match for tap hole button.
- Select the Fasteners →
Match for tap hole option from the menu.
- Press the
- The button stays depressed to indicate the selected option.
Эта страница получена от https://wiki.freecad.org/Fasteners_MatchTypeInner